|
Expert Editing Mode allows editing changes to be made piecemeal.
Each Expert Editor can be entered and closed in any order and as many
times as required before exiting from Expert Editing Mode. |
 |
| |
|
Individual Expert Editors may
be selected by touching any of the buttons at the top of the screen or, if
a keyboard is present, by pressing the corresponding hotkey.
Individual Expert Editors are: |
| |
Zones: |
Allows
Zones to be created or deleted, given names, enabled or disabled and assigned
signature colors. |
| |
Devices: |
Allows
Devices to be automatically detected, manually added or deleted;
imported from a file or exported to a file.
Parameters can be set or changed for any
device, including:
- Device Type
- Device Address
- Location
- Zone (if
Zones defined)
- Primary Load (if
Device can have Load
...)
+ Short Name (used
in Lights Task screen)
+ Local On Level
+ Local Ramp Rate
Device memory can also be erased to
remove any Links that may exist on the device -- this may assist in
determining the Primary Load for a Device in an existing network.
|
|
Cross-Links: |
Allows
Cross-Links to be established from any Switching Device (Master) to any
Loadable Device (Slave) and, in each case where the Loadable Devices
supports dimming, values to be set for the On Level and Ramp Rate to be
applied when the Link is activated.
Links can also be set up as two-way Links,
allowing the current status of the Slave Device to be displayed at the
Master Device.
|
The
following procedures may be used to select the various Expert Editing options: |
Desired
Action |
Touch |
Keyboard |
Show
this Help page |
Anywhere
on screen below buttons |
F1
key |
Hide
this Help page |
Red
title bar at top of Help page |
F1
key |
Open
Zone Editor |
Zones
button |
Z
hotkey |
Open
Devices Editor |
Devices
button |
E
hotkey |
Open
Cross-Links Editor |
XLinks
button |
L
hotkey |
Exit
from Expert Editing Mode |
DONE
button. |
D
hotkey. |
|
