• Preparing System For First Time Use . . .
• System Initialized . . .
• Performing System Checks . . .
• System Checks Completed . . .
• Looking for Local Configuration . . .
• No Local Configuration Found . . .
• Factory Reset Configuration . . .
• Looking for Connected Hardware . . .
• Checking COM1 for Insteon PLM . . . (etc.)
• Insteon PLM: XX.XX.XX Found on COM1
• Startup  Finished . . .

This HELP page can be viewed at any time by touching the yellow and orange logo symbol at the top left of the screen.  Alternatively, if a keyboard is present, the F1 key may be pressed.  This page may be closed by touching the red title bar at the top or by pressing the F1 key again.

The EXIT button can be touched at any time to terminate the application.  Alternatively, if a keyboard is present, the Alt/X combination may be pressed.  (Note: if any hotkeys are underlined in gray, the Alt key must be pressed with the hotkey to activate.  If they are underlined in the text color, only the hotkey is required).

(If a PLC 2414S is being used for the first time, the system will display a message after finding the PLC to request that the program should be restarted. This is because the system looks for a PLM 2412S first, and needs to unload the PLM 2412S drivers to preserve memory. This is not important on a PC, but is required to preserve memory on compact devices. This will only happen on the first time through, or if the controller is subsequently replaced with a different type of controller).